re-orienting cross sections
Posted: Fri Nov 25, 2016 12:55 pm
Hi,
If I extract 10 sections from a cloud (example below), then the slices will be in the same orientation than the original cloud. It is good for some application.
However, if I want to catalog all the sections in a printed report, I need all of them to be viewed from the orthogonal direction to the cutting plane. Is there way to do that automatically within CC ?
thank you
[img]
[/img]
If I extract 10 sections from a cloud (example below), then the slices will be in the same orientation than the original cloud. It is good for some application.
However, if I want to catalog all the sections in a printed report, I need all of them to be viewed from the orthogonal direction to the cutting plane. Is there way to do that automatically within CC ?
thank you
[img]
- Cc_section_extraction_ortho_sections.jpg (34.98 KiB) Viewed 1365 times