At flume scale, how to remove vegetation (alfalfa)?
Posted: Sat Mar 02, 2019 9:46 am
how can I remove vegetation from point clouds measured in a flume experiment with small alfalfa plants?
CloudCompare forum
Open-source point cloud editing software
https://cloudcompare-org.danielgm.net/forum/
At flume scale, how to remove vegetation (alfalfa)?
https://cloudcompare-org.danielgm.net/forum/viewtopic.php?t=3526
Page 1 of 1
Re: At flume scale, how to remove vegetation (alfalfa)?
Posted: Sat Mar 02, 2019 11:08 am
Can you show a screenshot of your cloud?
Re: At flume scale, how to remove vegetation (alfalfa)?
Posted: Thu Mar 14, 2019 3:23 pm
Re: At flume scale, how to remove vegetation (alfalfa)?
Posted: Thu Mar 14, 2019 3:24 pm
sorry, i didnt see your replay until now.!
Re: At flume scale, how to remove vegetation (alfalfa)?
Posted: Fri Mar 15, 2019 2:46 pm
Is it a 3D point cloud? (i.e. you have points below the vegetation) or a 2.5D?
In the first case, you could try the Canupo plugin (https://www.cloudcompare.org/doc/wiki/i ... O_(plugin)).
Otherwise, it may work with CSF (https://www.cloudcompare.org/doc/wiki/i ... F_(plugin))
In the first case, you could try the Canupo plugin (https://www.cloudcompare.org/doc/wiki/i ... O_(plugin)).
Otherwise, it may work with CSF (https://www.cloudcompare.org/doc/wiki/i ... F_(plugin))