CloudCompare forum

Posted: **Thu Jun 20, 2019 8:15 pm**

Hi all,

I am fairly new to using CloudCompare and its forum, but I haven't found a thread related to this question yet.
With version 2.10 many new calculation methods to produce geometrical features on the point clouds were added (https://www.cloudcompare.org/release/notes/20190106/).

Can these features be computed using the command line?

There is no column for this on the Wiki page yet, but I wondered if this just hasn't been updated yet (https://www.cloudcompare.org/doc/wiki/i ... _line_mode).

Respectfully,
Peter

Posted: **Thu Jun 20, 2019 9:08 pm**

No sadly! Not yet.

Posted: **Mon Jun 24, 2019 2:50 pm**

Hi Daniel,

too bad, but thank you for the fast response.

Peter

Posted: **Sun Mar 28, 2021 11:38 am**

I write in this topic because I'm interested too in the availability of this tool from the command line.

Posted: **Mon Mar 29, 2021 1:53 pm**

Yes, now most of them are:
https://www.cloudcompare.org/doc/wiki/i ... _line_mode

(see -FEATURE, -DENISTY, -ROUGH, etc.)

CloudCompare forum

Is the geometrical feature calculation available from the command line?

Is the geometrical feature calculation available from the command line?

Re: Is the geometrical feature calculation available from the command line?

Re: Is the geometrical feature calculation available from the command line?

Re: Is the geometrical feature calculation available from the command line?

Re: Is the geometrical feature calculation available from the command line?