CloudCompare forum

Hello All

I am looking into using this program in order to layout my floor pointcloud then create a grid around the edge for the sizes (E.G., bottom left is X1000, Y1000 and top right is X1050, Y1050). We do this currently programmatically but wish to move to a 3D version that I can overlay additional data like errors on the floors, contour lines and gradients.

Is this possible and can anyone point me to alternative tutorials?

Warm regards,
Ross

Sorry I'm not sure to fully understand what you want to do.

There's no 'grid' that you can overlay in CloudCompare. But you can project the cloud in a 'grid' (with the Rasterize tool).