Sensor Decimal character [FIXED]
Posted: Mon Sep 15, 2014 5:17 pm
Hi there again,
in the sensor creation or modifying windows, an error is not handled for decimal character.
If a comma is used by system, you can type positions X Y Z but CC assign then a 0 0 0. If you try to use a point as delimiter, you can't type into the textbox!
I know that an answer would be to change regional settings, but maybe CC should handle comma as well as points!
JF
in the sensor creation or modifying windows, an error is not handled for decimal character.
If a comma is used by system, you can type positions X Y Z but CC assign then a 0 0 0. If you try to use a point as delimiter, you can't type into the textbox!
I know that an answer would be to change regional settings, but maybe CC should handle comma as well as points!
JF